HELP!!! Wobbler Mechanic needed. Pay low. Appreciation high.
-
Wacky Nut
HELP!!! Wobbler Mechanic needed. Pay low. Appreciation high.
I have two 20" Wobblers that don't sit flat. The reason is that there are rods extending through the wobblers that are too long and push a bulge out on the bottom. There is a hole in the bottom of the base about the same size as the rod. The only thought I've had is to somehow cut a 1/2" of the rod. I don't know what to use to cut the rod since it would have to fit into that small hole. Any ideas? Any alternate suggestions? Does anyone else have this same problem?
- Sluggo
- Hall of Fame Class of 2008

- Posts: 1585
- Joined: Sun Apr 27, 2003 5:05 pm
Wacky Nut I've seen this problem on other 20" pieces too. I had a Bone Daddy that was so bad I sent it back to Tower Records for replacement. I wonder if that rod is even necessary? If not you could enlarge the hole just big enough to slip it out and then warm up the base just enough to make the plastic plyable and then flatten it back out. Well any way good luck my friend from a fellow Hoosier.
Sluggo
Sluggo
"Pixie & Dixie and Mr. Jinx, Please!"
"Just a pillow of the community"
"Just a pillow of the community"
- gregoman
- Hall of Fame Class of 2006

- Posts: 1952
- Joined: Tue Jan 06, 2004 1:39 pm
- Location: basement of the Alamo
- Contact:
-
kevinbuddha
- Hall of Fame Class of 2007

- Posts: 9418
- Joined: Mon Apr 28, 2003 11:06 am
- Location: Minnesota-where Sleestaks run free!
- Krusty
- Hall of Fame Class of 2006

- Posts: 609
- Joined: Tue Jun 24, 2003 3:45 pm
I had that problem with my 20" Underdog, and I resolved it simply by getting some of those adhesive pads that you can put on the bottom of chairs of tables. I put three of the pads on the base, equidistant from each other, and they act as a tripod. It now sits perfectly flat and still (except for the head, of course!).
K
K
-
kevinbuddha
- Hall of Fame Class of 2007

- Posts: 9418
- Joined: Mon Apr 28, 2003 11:06 am
- Location: Minnesota-where Sleestaks run free!
Who is online
Users browsing this forum: No registered users
